Friday, March 22, 2013

Power Mac G5 Modem Replacement Instructions

Warning: Always shut down the computer before opening it to avoid damaging its internal components or the components you are installing. Do not open the computer or attempt to install items inside it while it is on. 2. Wait 5 to 10 minutes to allow the computer’s internal components to cool. Warning: After you shut down the system, the internal components can be very hot. You must let thecomputer cool down before continuing. 3. Unplug all external cables from the computer except the power cord. 4. Touch the metal PCI access covers on the back of the computer to discharge any static electricity from your body. (Figure 1) Important: Always discharge static before you touch any parts or install any components inside thecomputer. To avoid generating static electricity, do not walk around the room until you have finished working and closed the computer.

Rev. A Figure 1 5. Unplug the power cord. 6. Hold the side access panel and lift the latch on the back of the computer . (Figure 2) Warning: The edges of the access panel and the enclosure can be sharp. Be very careful when handling them. 7. Remove the access panel and place it on a flat surface covered by a soft, clean cloth. Figure 2 Power Mac G5 Modem – 2 8. Remove the air deflector and place it on a soft, clean cloth. (Figure 3) Figure 3 Important: Always remember to replace the air deflector after you have finished working inside yourcomputer. The Power Mac G5 computer will not function properly if the air deflector is not replaced. Power Mac G5 Modem – 3 Removing the Installed Modem.


No comments:

Post a Comment

Note: Only a member of this blog may post a comment.